Cradle & Cable

Boat Lift Repair in Fort Lauderdale

Boat lift repair in Fort Lauderdale starts with what the lift is doing. Stuck up, stuck down, or making a new noise?

Get a free match

Call or text (754) 283-9734

Call now or send a text with your address and what you need.

Switches and shore power before a storm

The National Hurricane Center's marine guide covers the wiring side.

Remove expensive equipment and loose gear in case of theft or sinking. This includes the electronics mounted in covered boxes. The cost of reinstalling equipment including splicing wires and cables is cheaper than replacement of costly electronics. Use tape and plastic sheeting to tightly seal any electronics that cannot be removed. Consider that the wind force can bend plastic and separate seals creating gaps exposing sensitive equipment to elements. Use tape to seal all switches and cable connector ends. Tape around the doors of electronic panels. Use tape in an overlay shingle pattern to protect instrument faces including compasses, and tape close any instrument dash holes. Remove tape as soon as possible after the storm, preferably, before the sun has time to heat up the tape adhesive.

Disconnect shore utility services. Commercial electric power will be lost so store the shore power cables. Turn off all DC breakers except for main and bilge pumps. Seal the vessel as watertight as possible because bilge pumps may not be able to keep up the combination of heavy tropical rains and waves. Do not plug deck or cockpit scuppers; instead make sure they will remain clear.

Source: National Hurricane Center, “Tropical Cyclone Concerns for Marine Interests”, pages 11 to 12. Quoted word for word, pulled Nov 21, 2026.

Motor trouble has its own page: boat lift motor repair.

Repair or a new lift?

They aren't always the same paperwork. Florida's environmental permit rule names lifts more than once.

(d) Replacement or repair of existing docks and piers, including mooring piles, in accordance with Section 403.813(1)(d), F.S., provided the existing structure is still functional or has been rendered non-functional within the last year by a discrete event, such as a storm, flood, accident, or fire.

(f) The construction, installation, operation, or maintenance of floating vessel platforms or floating boat lifts in accordance with section 403.813(1)(s), F.S.

(h) The installation of a pile-supported boat lift within an existing mooring area at a docking facility that is legally in existence, provided:

1. Such installation does not conflict with a condition of a permit issued thereunder;

2. The boat lift does not include additional structures, such as platforms, cat walks, and roofs.

(c) Construction of private docks or piers of 1,000 square feet or less of over-water surface area in artificial waters in accordance with Section 403.813(1)(i), F.S., and within residential canal systems legally in existence under Chapter 403 or Part IV of Chapter 373, F.S. This includes associated structures such as roofs and boat lifts, provided the cumulative square footage of the dock or pier and all associated structures located over wetlands and other surface waters does not exceed 1,000 square feet.

Source: Florida Administrative Code Rule 62-330.051(5), paragraphs (d), (f), (h) and (c). Quoted word for word, pulled Nov 21, 2026.

What a storm does to a dock

This dome of salt water can be 50 mi (86 km) wide and 5-15 ft (1.5-4.5 m) higher than the normal tide. The water will rise above many fixed docks with the tethered boats then floating above the docks. During the category 4 1926 Miami hurricane a 10-12 ft (3-4 m) surge covered Miami Beach, Biscayne Bay and Key Biscayne. A sailboat with a 7 ft (2 m) keel crossed the Key Biscayne peninsula during the storm surge. Boats can also end up on a sea wall or in permanent dry dock. During Alicia in 1983, a 10 ft (3 m) surge moved barges across I-10 into a lagoon resulting in a total loss of the vessels. Category 5 Hurricane Camille was accompanied by a storm surge up to 26 ft (8m). Three ocean-going vessels were dry docked and had to be cut up and salvaged. Reefs do not protect land or islands. Although a reef extends all along the Florida Keys, hundreds of people died in the storm surge during the great Labor Day Hurricane of 1935.

Source: National Hurricane Center, “Tropical Cyclone Concerns for Marine Interests”, page 3 (updated June 7, 2016). Quoted word for word, pulled Nov 21, 2026.

After a storm, start on the storm damage page.

Why keep the boat out of the water

Florida's Clean Marina guide asks marinas to promote boat lifts.

Environmental Issue

Boatyard employees and boat owners use a variety of boat cleaners, such as teak cleaners, fiberglass polishers and detergents, that can contribute to pollution and nutrients to the water. Excess nutrients degrade water quality by promoting nuisance aquatic plant growth and reducing dissolved oxygen levels needed for aquatic life. Additionally, scrubbing anti-fouling paints can release toxic metals into the water that can contaminate boatyard bottom sediments. The removal of contaminated sediments can be very costly.

Goal

For boats that are in the water, use cleaning methods that prevent or contain the release of pollutants to surface waters.

Best Management Practices

Educate customers on the negative impact of many traditional cleaners and, when possible, supply for sale to boatyard patrons biodegradable spray type cleaners that do not require rinsing.

When possible, remove the boat from the water to perform cleaning where debris can be captured and properly disposed.

Promote the use of dry slips and boat lifts in order to reduce the need for in-the-water cleaning.

Source: Florida Department of Environmental Protection, “Florida Clean Marina Best Management Practices”, section “Boat Cleaning in the Water”, page 37. Quoted word for word, pulled Nov 21, 2026.